Group Exercise Elliptical
8
•
The tension adjustment cable and speed sensor wire are pre-installed to the console mast
and main frame so be careful not to pull too hard on the console mast during assembly to
avoid damaging them. Connect the two speed sensor wires together.
•
Lift the console mast (2) into place and align it so the locating pins in the mounting plate are
set into the holes in the mating plate of the main frame.
Be careful not to pinch the speed
sensor wire between the console mast and the main frame plates during assembly.
•
Secure the console mast in place with the four M10 x 20mm stainless steel bolts (58) and
M10 split washers (65). Make sure the bolts are securely tightened.
•
Install the stationary handlebars (3) to the console mast with four M10 x 20mm stainless
steel bolts (58) and M10 split washers (65). Make sure the bolts are securely tightened.
STEP 1: CONSOLE MAST
