page-17
10155
OPERATION OF YOUR TREADMILL
DOT MATRIX CENTER DISPLAY
Twenty columns of dots (8 high) indicate each segment of
a workout. The dots are only to show an approximate level
(speed/incline) of effort. They do not necessarily indicate a
specific value – only an approximate percent to compare
levels of intensity. In operation, the speed/incline dot matrix
window will build a profile “picture” as values are changed
during a workout. When the word “Speed” is lit above
the dot matrix it indicates that the Speed profile is being
displayed and when the word “Incline” is lit above the dot
matrix it indicates that the Incline profile is being displayed.
PULSE FEATURE
The Pulse (Heart Rate) window will display
your current heart rate in beats per minute
during the workout. You must use both
stainless steel sensors on the front cross
bar to display your pulse or wear the
wireless chest strap. The pulse value
will display anytime the upper display is
receiving a pulse signal.
CALORIE DISPLAY
Displays the cumulative calories burned at any given time during your workout.
Note: This is only a rough guide used for comparison of different exercise sessions, which cannot
be used for medical purposes.
There is an Audio Input Jack ( ) on the front of the console and built-in speakers. You may plug
any low-level audio source signal into this port. Audio sources include MP3, Ipod, portable radio,
CD player or even a TV or computer audio signal. There is an audio patch cable included and also
a headphone jack ( ) for private listening.
TURNING OFF TREADMILL
1. The display will automatically turn off – go to sleep – after 30 minutes of inactivity when in the
Pause / Stop mode.Almost all power for the treadmill will be off except for some circuits that
are needed to detect if any key is pressed, indicating the console should “wake up”. When the
console is “asleep” the treadmill draws very little power, about as much as your television when
it is turned off.
2. Removing the safety key is similar to entering “sleep” mode. Turning off the main power switch
in the front of the treadmill will completely remove any power.
You may change the Dot Matrix profile view between Speed and Incline by pressing the ENTER
button. After pressing select to view the two profiles, pressing the select button a third time will
automatically alternate the Speed and Incline displays,showing each one for five seconds.
1/4 MILE TRACK
The 1/4 mile track is displayed around the dot matrix window. The flashing dot indicates your
progress. The number of laps you complete are accumulated in the lap counter, which is below the
Pulse window.
Summary of Contents for F7600
Page 11: ...page 9 10155 EXPLODED DIAGRAM ...
