Customer Service 1-888-707-1880
Dyaco Canada Inc. 2016
Email: [email protected]
30
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger
wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this
point enough; 90% of calls to the service department for noise issues can be traced to loose
hardware.
II. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the front and 2 leveling pads on the back of the unit.
STEP RAIL AND CARRIAGE MAINTENANCE
Dirt and dust can accumulate on the pedal carriage components causing a
rough feel which means the rails and wheels most likely need cleaning.
1. Remove mast cover and center cover.
I. Firmly press in at the bottom of the small mast cover at the front
and rear and pull up.
II. Firmly press in at the top of the main cover near the top and pull up
on the center cover. Repeat this process at all four corners of the
cover.
III. Slide the mast and center covers up the mast tube. Tie a rag
around the tube and let the covers rest on it so they stay in place.
2. Move the pedals so one is all the way forward. Clean the wheels and
rails using a rag and alcohol.
3. Replace the covers when done.
