Customer Service 1-888-707-1880
Dyaco Canada Inc. 2021
Email: [email protected]
7
EQUIPMENT OPERATION
INSTRUCTIONS
To begin using the CVC800 Vertical Climber, please follow the steps below:
First step: Please hold the stationary handlebar ( A1 position).
Second step: Stand on the pedal ( B position).
If you want to stop using the CVC800 climber, please follow the correct steps to get off:
First step: Please stop workout from your climber.
Second step: Please remove your foot from pedal (B position), but don’t remove your hand from
the handlebar ( A1 position).
Third step: Remove your hand from the handlebar when your foot is stable and on the floor.
GENERAL MAINTENANCE
Wipe down C&D areas in the sweat path with a damp cloth
after each use to prevent rust.
Please use a dry cloth to wipe the driving parts (D assembly) every week.
Check the pedals to make sure they are tight (monthly).
If a squeak, thump, clicking or rough feeling develops, the main
cause is most likely one of two reasons:
1. The hardware was not sufficiently tightened during assembly. All
bolts that were installed during assembly need to be tightened as
much as possible. It may be necessary to use a larger wrench than the
one provided if you cannot tighten the bolts sufficiently.
I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
2. The handlebar and/or the pedals need to be retightened.
If squeaks or other noises persist, check that the unit is properly
levelled.
WARNING
1. The effect that the safety level of the equipment can be
maintained only if it is examined regularly for
damage and wear.
2. Replace defective components immediately
and/or keep the equipment out of use until
repair.
3. The components which are most susceptible to
wear:
Belt, Shaft, Bearing, Idler and Pedal.
