Spinning SPINPower Studio Crank, Owner'S Manual

Page: 13 / 20

www.spinning.com 800.847.SPIN (7746)
SPINPOWER® STUDIO CRANK OWNER’S MANUAL
INSTALLING THE
SPINPOWER® CRANK
At this point in the process, the “stock” crank has been removed.
Prepare the bottom bracket axle.
Note that the exposed bottom bracket axle is a
square taper. It will be important to mount the crank
so that the pedal is in the opposing position of the
drive (right) side.
Install the crank.
1. Locate the correct crank orientation on the 4 sided
taper so that the pedals are on opposite positions on
the clock (12 and 6). For best resuls, add a small amount
of lithium grease to the flats of the exposed axle taper.
Now push the crank onto the axle as shown.
2. Once the crank is on, hand-thread the crank bolt
clockwise onto the axle. Now use a 14mm torque
wrench to tighten the bolt to 35-40 ft-lbs (47-57 Nm).
Do not overtighten the bolt.
13