Spinning SPINPower Studio Crank, Owner'S Manual, Page: 12 / 20

8. Once started by hand, use a wrench on the crank
removal tool and turn it clockwise to thread the tool com-
pletely into the crank until it is snug. Do not over tighten.
9. Once the tool is fully threaded into the crank, use
a wrench to turn the removal bolt clockwise into the
crank. It might take a few turns that might require
heavy force. The center of that tool will engage with
the bottom bracket axle and will allow the tool and
crank to ”pull” away from the bottom bracket axle.
Once the crank starts to pull away, stop turning the
removal bolt and wiggle the crank off of the axle.
When the crank is off, use an open end wrench to
unthread the tool from the crank.
REMOVING YOUR
EXISTING CRANK
(continued)
12