www.spinlock.co.uk
30
31
Converting XX0812 to XX0812/L lock open version
XX0812 to XX0812/L
XX0812 to XX0812/L
XX0812
how to use
pages 14-15
installation
pages 20-21
spares
pages 34-35
The XX0812 can be converted to the XX0812/L with the purchase
of the XX-LCK.
Fitting procedure:
1.
Check kit components before commencing (Diagram 1).
2.
Lift handle 50mm to gain access to the M5 Allen screw on the top
surface that retains the rear moulding. Remove this screw.
3.
Hold rear cover at top and rotate and pull out from the top.
4.
Pull the complete rear moulding and jaw assembly free from the body.
5.
Remove Latch Pivot Pin (diagram 2).
6.
Insert Latch Spring and Latch Lever Support into Latch Lever (diagram 2).
7.
Insert Latch assembly into rear moulding from rear (diagram 3).
8.
Insert jaw spring ends into latch lever support, such that the spring
coils align with holes in latch support.
9.
Push Latch Lever and Lever Support together and locate with Rear
Cover to allow all holes to align.
10.
Push pin through holes in Rear Cover, Latch Lever, Latch Support and
Spring Coils. An audible ‘Click’ will be heard (Diagram 4).
11.
Insert jaw assembly in body of XX.
12.
Angle rear moulding backward, to locate lower fixing hooks in body.
13.
Rotate top of cover into place flush with XX body.
14.
Insert M5 Allen screw on the top surface that retains the rear
moulding. Hand tighten only.
15.
Ensure lock open latch is fully operational in both up and down
positions as well as opening and closing the handle fully.
16.
Put latch into ‘Up’ position and Insert rope through XX body.
3
1
4
2
