www.spinlock.co.uk
18
ZS–RLB Remote Lockback Switch
Installation
19
Installation
ZS-RLB
how to use
pages 12-13
spares
pages 34-35
For use with ZS1214, ZS1618, ZS1014C, ZS1618C, ZS1014B and ZS1618B
Jammers or existing halyard locks. Allows the ZS Jaws to be pre-tensioned
for release.
1.
Mount the ZS-RLB in it’s preferred location using M5 fasteners.
2.
Choose a suitable very low stretch control line 2-4mm which can be
spliced.
2.
Attach the control line to the jaw set using a thumb knot or similar -
see diagram below. Remove rear block and jaw step ( see page 22).
3.
Thread the control line through the spring and rear blockand fasten
the rear block into place.
4.
With the control line cut to approximately the correct length, splice the
control line to the eye of the RLB-Spring using an adjustable splice.
5.
Ensure the control line has a free, un-interrupted, low friction run
to the jammer. If necessary use bulls eyes or blocks to ensure a
smooth run.
6.
With the jaw set loaded on the correct diameter line and the RLB
closed adjust the control line splice so it is just taut.
7.
Check operation as described (see page 12 and 13). Some adjustment
may be necessary before making the splice permanent.
8.
Changes in the rig set-up or line diameter will require the control line
splice to be adjusted.
Open
Closed
