MAINTENANCE
&
SERVICING
Service Instructions
1
s supply.
the appliance is Dual Fuel, disconnect/isolate the electric supply.
2.
emove hob surface
nd
fascia retaining screws. Carefully lift off the fascia and if spark ignition fitted
remove the two spade connectors from the rear of the toggle switch. Remove the
ove the two
ed through the outer slots on
the angled front. Grasp the hob by the angled front face, carefully lift the hob
the front to allow the rear edge to unhook from the rear box section.
e
e put onto a suitable surface.
3.
Remove appliance from housing
n the oven door and remove the 2 screws from
pply lead from rear
nce out onto a suitable surface.
4. Co
Ho
emove hob surface (2). Unscrew the
cor
Op
rear of oven. Remove
the
pip
it on
the
Ov
As above instructions but remove appliance from housing to gain access to the
oven thermostat, grill and oven thermocouples.
ce from housing (3). Remove hob
surface (2). Remove the two screws retaining the heat deflector. Remove the
insulation wrap and lever off the two starlock washers retaining the grill burner. Lift
out the burner assembly.
.
isconnect from gas supply
D
Lift and remove the bottom plinth to gain access, then disconnect the ga
If
R
Disconnect from gas supply (1) and electric supply if Dual Fuel. Lift off the Panrest
and remove the two screws securing each burner spreader. Remove front fascia by
removing all push on control knobs and unscrew the two recessed fixed nuts a
both
two central screws securing the pressing to the rear box section. Rem
front retaining screws located each side and access
surface from
Note:- On Dual Fuel appliances, remove the hotplate rear cover and disconnect th
power leads. The hob surface should b
Disconnect from gas supply (1). Ope
each side trim - note the appliance can either be front or side fixed, see under
Fixing,
page 17. Open the glass lid and remove the 2 screws from each side trim.
Carefully slide the appliance out one third and check for any possible snagging of
wires or pipes. If the appliance is Dual Fuel, disconnect su
terminal block. If OK, lift applia
ntrol replacement
b controls
Disconnect from gas supply (1). R
responding pipe and thermocouple and remove from the control.
en the oven door and unscrew the 2 screws holding the thermostat probe in
position and push the probe back out through the hole in the
retaining screws from on top and underneath the control. Disconnect the inlet
e and two burner supply pipes. Remove the fittings off the old control and f
replacement.
en and Grill control
5.
Remove the grill burner
Disconnect from gas supply (1). Remove applian
20
