INSTALLATION
Regulations and Standards
own interest of safety, gas appliances should be installed by competent persons.
ms.
for
In your
Failure to install the appliance correctly could invalidate any warranty or liability clai
This appliance shall be installed in accordance with the manufacturers installation
instructions, local and state codes or, in the absence of such codes, with the Standard
Recreational Vehicles,
ANSI A119.2.
Data label.
The data label is located on the right hand side front of the oven compartment, behind the
ven door. Ensure that the gas supply is Propane. This appliance is designed for use
ith Propane gas and should not be converted for use with any other gas.
o
w
Ventilation
This appliance is suitable for installation into Holiday Homes, Touring Caravans and Boats.
In all cases the national standards with regard to ventilation for the particular vehicle into
which the appliance is to be
The appliance
M
osure having the following ventilation:-
•
A g
esc
eneath the appliance and positioned
at t
rea
T
vent to the outside and have a cross-
sectional ar
2
) and should be baffled to
pre
nt di
•
A h h lev
liance in either the worktop or direct to
the outside – see
×
Fig. 1 & 2, with a cross sectional area of minimum 4in
2
(2400mm
2
). If vented to the outside a baffle should be attached to prevent direct
draught to the appliance.
Location of Appliance
installed must be adhered to.
UST
be installed into an encl
as
ape hole in the floor, directly b
he
r – see
¯
Fig. 2. The hole
MUS
2
2
ea between 3in and 6in (1965 to 3850mm
ve
rect draught to the appliance.
ig
el rear vent, directly behind the app
This appliance maybe installed in a kitchen/kitchen diner but NOT in a room containing a
bath or a shower. LP gas appliances must not be fitted below ground level. e.g. basement.
Choose a location free of draughts, open doors and clear of combustible materials and
other fire hazards. The location should ensure convenience of operation and service. Any
adjoining wall surface situated within 4
1
/
2
in (115mm) from the cooker side – see Fig. 3,
must be made from a suitable non-combustible material for a height of 6in (150mm) for
the hotplate.
the entire length of
Position
CAUTION: DO NOT LIFT APPLIANCE USING THE DOOR HANDLES
The appliance must be installed in such a
follows
becaus o
tempe
u
Temp
n Procedure
way that the furniture fitted around the unit
the minimum dimensions as shown in Figs. 1, 2 & 3. If this cannot be adhered to
f design constraints, then the design is de
e
emed permissible providing that the
rat re rise on the furniture is tested by undertaking following procedure.
erature Verificatio
Pla
ate burners and fill up
3
/
4
with
water. Turn on all 3 hotplates and the oven on full. After 45 minutes turn off the
oven and turn on the grill to full. After a further 15mins establish the highest
temperature points on ALL the furniture surfaces in direct line of sight of the
appliance. The temperature rise must not exceed 149
0
F ( 65
o
C) above the ambient
temperature, or where applicable, must not exceed the maximum allowable
temperature, to avoid damage, as detailed within the material suppliers
specification.
ce 3 large pans (20-22cm Ø) on top of the hotpl
16
