77-2800-R-T - Instructions HONDA TALON Rear Vent Tinted Windshield - rev00
www.spikepowersports.com / 888-769-2295
3
IMPORTANT NOTICES
Torque specifications must be followed when tightening bolts.
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
warranty.
d)
Install windshield to the clamps using supplied screws and washers without applying
final torque. Ensure that the windshield and all clamps are properly positioned. Secure
all clamps in locking position [Ref: Step 4 - section c] and tighten all screws as shown
below.
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
CLEANING:
▪
Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
or use brushes or squeegees.
▪
Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
▪
To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
rinse. DO NOT USE GASOLINE.
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
light transmission and coating delamination.
Compatible Cleaning Agents
▪
Aqueous Solution of Soaps and Detergents
Joy
Freon T.F.
Palmolive liquid
Top Job
VM&P grade Naphtha
Windex
(with ammonia D)
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
Windshield
Philips truss head
screw M6 x 16 (4x)
(
5.0 ± 0.5 N•m / 44 ± 4 lbf•in
)
Shoulder washer
M6 (4x)
