77-2800-R-T - Instructions HONDA TALON Rear Vent Tinted Windshield - rev00
www.spikepowersports.com / 888-769-2295
2
IMPORTANT NOTICES
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
warranty.
b)
Find a clean flat area where you can safely lay down the windshield.
Partially remove the protective film on both sides and install the vent
grill (Item B) using supplied hardware (Item E) as shown.
c)
Attach the clamps to the roll-cage as shown below and pre-adjust tightening tension of all clamps. N
OTE: Keep all clamp handles
open as shown in step 3 below; this will allow you to move the clamps up or down when installing the windshield for the first
time.
To apply more or less tension to the roll cage, simply rotate the clamp
handle from the tension screw as shown below. Over tightening clamps
to roll-cage could cause parts failures.
Step 1
(passenger side)
Step 2
(passenger side)
Step 3
(passenger side)
Step 4
(passenger side)
(passenger side)
Clamp
handle
Clamp in
locked
position
Details
Carriage bolt
M6 x 30
Thin plastic
washer
Plastic
washers M6
Female knob M6
Rubber washer M6
Vent grill (#T5)
Upper clamp
(passenger side)
Lower clamp
(passenger side)
Clamp handle on the outside
(for seat belt clearances)
Clamp handle on the
inside of the cab
