SK597-AT4
Operating the truck
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 1.2
3-31
M
ei
2
0
1
8
C
h
a
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
8
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
3.9.2.4.
Main screen: Tyre pressure screen
Using
switch 6
on the control panel the
tyre pressure screen
) can be displayed.
In the top bar A of the screen the current warnings ar shown in red and yellow.
If more than 7 warnings are active, all these warnings can be displayed on another screen
(see
§ 3.9.2.6. Main screen: Error screen
).
For explanation of the used symbols, please refer to
If the tyre has the prescribed tyre pressure (see
§
), a transparent (black) tyre will
be visible at the corresponding axle (see
).
If the tyre pressure is high or low, the tyre will be yellow (see
).
There will also be a continuously yellow warning in
warning bar
A
(see
If the tyre pressure is too high or too low, the tyre will be red (see
).
There will also be a red warning in warning bar A (see
).
In the
I
f there is a “lightning bolt” displayed at the tyre instead of a number (see
),
then there is no measured value of the tyre pressure (no sensor signal available).
If no sensor signal is measured successively after 60 minutes, the yellow icon will appear in the
warning bar A
) and the user must check if all remote controls (belonging to the crane)
are disabled, so they can not cause interference. If the icon still lights, then the user must have the tyre
pressure system checked by Spierings Service. The battery of the sensor may be empty.
I
f all tyres are displayed with a “lightning bolt” and this icon is flashing in the warning bar,
then there has been a CAN-bus fault.
Picture 3-13
CAUTION!
Make sure the remote controls (which belong to the crane) are disabled,
so they cannot cause interference in the tyre pressure system.
C
A
D
B
E
