SPIDO COMBO-10, Instructions For Use Manual

Page: 35 / 56

EN
Place the Multi-Port Valve in the
«4 - Backwash» position.
Reconnect to power source.
Run filter in BACKWASH mode until
discharge water is clear.
Disconnect the Motor/Pump from
the Power Source.
Place the Multi-Port Valve in the
«2 - RINSE» position.
It is important that you read and follow
the instructions on proper power
supply sources.
Reconnect to power source.
Allow filter to run for 60 seconds to
remove any remaining residue from
pump and valve.
Disconnect the Motor/Pump from
the Power Source.
Place the Multi-Port Valve in the «1
- Filtration» position.
Reconnect to power source.
Your filtration system is RUNNING and
ready for further operation.
Filtration time
Depending on the load and the size of
the installation, the pool water should
circulate at least 3 to 5 times through
the filter within 24 hours. The time
required depends on the performance
of the filtration group and the size of
the pool. We recommend a minimum
operating time of 12 hours per day.
7. WINTERIZE
1) Unplug the pump from the power
source.
2) Close the shut off valves or block
the flow of water al the pool inlet and
return ports.
3) Disconnect the filtration system from
the pool, drain the tank and hoses.
4) Place the handle on the central
valve in position 7- “Winter ize” to
relieve the tension on the spring and
internal valve components.
5) Store the filter system in a location
protected from frost and severely cold
temperatures. ln a garage or insulated
stor age shed is recommended.