0
0
4
/
0
5
3
/
0
0
3
/
0
3
2
/
0
6
1
S
o
m
r
e
h
T
r
i
a
p
e
R
8
806
8.6
Electronic ignition unit and ignition
electrode removal and installation
Removal
1. Remove burner (see 8.2).
2. Lift off ignition electrode (2, Fig. 804) from the
electronic ignition unit by twisting a screwdriver
sideways.
3. Remove disc (3).
4. Removes screws (4) with retaining washers.
5. Pull electronic ignition unit (1) off and remove it.
6. If necessary, perform a general visual inspection (see
5.5.1) or test (see 5.5.8).
Installation
1. Bring electronic ignition unit (1, Fig. 804) into
installation position, attach ready for connection and
secure with screws (4).
2. Tighten screws (4) with 5 Nm +1 Nm.
3. Fit disc (5) onto the nozzle holder of the fuel pump
(9, Fig. 805) and align with the flame detector in the
control unit (14, Fig. 805) and the electronic ignition
unit.
4. Fit the ignition electrode (2, Fig. 804).
5. Install burner (see 8.2).
Fig. 804 Removal of the electronic ignition unit / ignition electrode
1
2
1
Electronic ignition unit
2
Ignition electrode
3
Disc
4
Screws (2)
3
4
Summary of Contents for Thermo S 160
