21
1. Select “Log Setting” from the Setting options.
The Logger Setting menu displays.
2. Select the “Alarm & Sensor” tab.
3. The default alarm value of 1000 ppm displays. Adjust the
▲or ▼indicators to change the value. Alternatively, click
on the field and type in the new value. Continue
by setting the logger sampling parameters, below.
Logger Sampling Setting
4. Select the “Setting” tab.
5. The monitor sampling range is 1 second to 6:59:59.
Adjust the ▲or ▼indicators to specify the sampling rate in
hours, minutes, and seconds.
6. Adjust the ▲or ▼indicators to select Immediate, Roll
Over, Schedule or Key start mode.
Setting Immediate Start Mode
This option will cause the monitor to begin taking readings
as soon as the option is confirmed. Reading will continue
when the monitor is detached from the USB port.
1. Adjust the ▲or ▼indicators to specify the number of
sample points, in thousands, from 1000 to 32,000.
2. Adjust the ▲or ▼indicators to toggle between units:
°C or °F.
3. Select “Ok” to save the settings and exit the menu, or
“Cancel” to exit without saving the new settings.
