9
3. Press ◄ or ► to advance to the next parameter.
4. Press
MEM
to save the selection and toggle to the next
setting. Otherwise, press
SET
to exit setup mode.
Audible and Visible Alarms
High and low alarm values may be set for all parameters.
1. Press
SET
to enter setup mode.
2. Press
MEM
to toggle through the settings until
ALARM
appears at the bottom of the screen. Press ▲or ▼ until
the word “On” appears on the screen.
3. Press
MEM
to advance into the alarm settings.
4. Use the ◄ or ► to advance through the placeholders and
the ▲or ▼ buttons to change the numbers. Press
MEM
to save the selection and toggle to the next parameter.**
**Note: The alarm function is either on for all parameters
or off for all parameters. The best way to alarm only one
parameter is to set the values of the unwanted parameters
to something not possible during your measurement period.
For example, if you don’t want the humidity to alarm, set the
high for 99% and the Low for 0%.
5. Continue to set the High and Low alarms using the ▲or ▼
buttons for each parameter.
6. Press
MEM
to save the selection and toggle to the
next setting. Otherwise, press
SET
to exit setup mode.
