34
SPEKTRUM DX8e • TRANSMITTER INSTRUCTION MANUAL
EN
Telemetry is in both the system setup and the function list so you
can access the telemetry functions from either list.
You must power off the receiver and transmitter, then power them
both on to reset the telemetry data. You can reset min/max values
by pressing the
CLEAR
button.
NEVER
change Telemetry settings when the aircraft is powered
on. There is a brief interruption in RF output when exiting the
Telemetry screen, and may cause a “Hold” condition.
FUNCTION LIST
Telemetry
Press NEXT to select the Timer Event Alerts settings. These
include options for the alerts at every minute for down timers, 1
minute remaining alert, 30 seconds remaining alert, 10 second
to 1 second remining alerts, expiration alert, and every minute up
alert. Press NEXT again to select the Timer Control Alerts settings.
Available options include Timer Start alert, Timer Stop alert, and
Timer Reset alert.
4
Timer Event and Timer Control Alerts
Use System Setup to enter the System List from the Function list
without turning the transmitter off. A Caution screen will appear
that warns that RF will be disabled (the transmitter will no longer
transmit). Press
YES
if you are sure and want to access the System
List. If you are not sure, press
NO
to exit to the main screen and
continue operation.
If you do not press
YES
or
NO
, the system will exit to the main
screen and continue operation within approximately 10 seconds.
WARNING:
Do not press
YES
unless the model is turned
off or the model is secured.
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions, trim settings, mix directions, etc. The numeric value
is directly relative to the travel adjust and mix values (e.g. 100%
travel adjust equals 100% value in the Monitor).
System Setup
Monitor
