EN
7
Initial Setup
1.
Verify your transmitter is updated to the latest Spektrum AirWare™ software
to take advantage of Forward Programming. See your transmitter manual
for updating instructions.
2.
Install the receiver in your airplane.
3.
Bind the receiver to your transmitter.
4.
Complete the airplane setup on your transmitter including wing type, tail type, channel
assignments, mixing, sub trim and travel the same as you would for any other aircraft
without AS3X. Verify the center of gravity is correct and test fly your aircraft.
IMPORTANT:
Do not use open mixes for flight control surfaces when setting
up a model with the AR630 for AS3X and SAFE. Only use wing and tail type
options to configure flight controls, refer to your transmitter manual for more
information about wing and tail type features.
Testing Failsafe
Secure the aircraft on the ground and remove the propeller. Test Failsafe
settings by turning the transmitter RF output off and noting how the receiver
drives the control surfaces.
Receiver Power Only
• The servo ports will not have a control signal if the receiver is turned on
when no transmitter signal is present.
• All channels have no output until the receiver has linked to the transmitter.
