EN
22
Problem
Possible Cause
Solution
Aircraft will not
respond to throttle
but responds to
other controls
Throttle not at idle
and/or throttle trim
too high
Reset controls with throttle
stick and throttle trim at
lowest setting
Throttle servo travel
is lower than 100%
Make sure throttle servo travel
is 100% or greater
Throttle channel is
reversed
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Motor disconnected
from ESC
Make sure motor is connected
to the ESC
Aircraft will not
Bind (during bind-
ing) to transmitter
Transmitter too
near aircraft during
binding process
Move powered transmitter
a few feet from aircraft, dis-
connect and reconnect flight
battery to aircraft
Aircraft or transmitter
is too close to
large metal object,
wireless source or
another transmitter
Move aircraft and transmit-
ter to another location and
attempt binding again
The bind plug is not
installed correctly in
the bind port
Install bind plug in bind port
and bind the aircraft to the
transmitter
Flight battery/
transmitter battery
charge is too low
Replace/recharge batteries
Bind button not held
long enough during
bind process
Power off and repeat bind
process
Troubleshooting Guide
