STRIKER®-8
SpeedTech Lights, Inc © 2018
5
How the STL Direct II Control® Box Operates Your STL Light Bar
Power Switch
•
Push this button to turn On/Off the unit.
Flash Mode Button
•
Switches back from Traffic Advising mode to Warning mode.
Flash Pattern Button
•
Button cycles to the next flash pattern with each press. Non-Volatile memory recalls the last flash pattern selected.
Left Button
•
Toggles Left traffic advisor pattern
Center Out Button
•
Toggles Center Out traffic advisor pattern
Right Button
•
Toggles Right traffic advisor pattern
Slow/Fast Slide Switch
•
Toggles between Slow and Fast flashing speed
*Aux [Red (+) Positive] and Blue [(-) Negative wires]
•
Rated for 10 AMPs
•
1st press: Power ON unit attached to aux cables
•
2nd press: Power OFF unit attached to aux cables
Wiring: Connecting Wires to the Battery
WARNING!
If you are supplying your own wiring that connects to the positive or negative terminal of the battery, fuse sizes must be sized accord-
ing to STL’s provided fuse to be considered fused properly to the battery in order to carry the load.
•
Route the power cables by opening the wiring shield and running the cables through it towards your vehicle’s firewall.
•
Follow the factory wiring harness through the firewall.
•
If it is necessary to drill a hole in the firewall for the power cables, be sure no components will be damaged from drilling. As with all holes
that are drilled, file the edges down smooth and insert a grommet to protect the cables.
•
Route the cable along the factory wiring harness towards the battery.
•
Wire your power cables (Red with In Line Fuse (STL Supplied) and Black cable) to your battery to power up your Light Bar.
•
You will want to ensure your grounding cable is taken directly to the negative terminal of your battery to avoid any electrical feedback
which may disrupt your Light Bar system.
•
DO NOT allow the positive (Red wire) and negative (Black wire) to touch one another. This may cause injury to you and damage your equip-
ment by causing a short in the unit that is not covered under the STL warranty.
