Washer Symptom
Possible/Cause Solution
Er
,
nF
on digital display
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed
within 5 minutes of the current fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Er
,
OF
on digital display
• This code indicates the washer has filled to the overflow
level.
• The machine will begin to attempt to pump water out if the
door is closed and locked.
• Foreign object trap in pump may be clogged. Clean the
trap. Refer to Maintenance section.
• If the code does not clear, unplug the machine and call for
service.
Er
,
PS
on digital display
• The control has detected trouble sensing the water fill lev-
el.
• Unplug the machine and call for service.
Er
,
dU
on digital display
• The control senses that the door will not unlock.
• Unplug the machine for three minutes to unlock the door.
• If the code appears again, call for service.
Er
,
dl
on digital display
• This code indicates that the door has not locked.
• Make sure the door is closed all the way and try to start
the cycle.
• Open the door or unplug the machine to clear the code.
• If this code continues, call for service.
Er
,
ub
on digital display
or
Left Decimal Point blinking on display one second on/one
second off
• This code indicates that the washer did not reach the maxi-
mum intended speed in the final spin.
• This could be due to an unbalanced load, excessive suds
in the load, or too much water left in the tub due to slow
draining.
• Be sure to use proper load sizes that are evenly distributed
in the wash basket.
• Be sure to use high efficiency (HE) detergent.
• Open the door or press the Power/Cancel keypad to clear
this code.
PF
on digital display
• This code will be displayed if the control was in Delay Start
Mode when a power failure occurred.
• The delayed start will be canceled.
• Press the Power/Cancel Pad to clear the code.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
30
Part No. 806974EN
