Installation
M414905
22
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
9. Place front panel on machine, loosely attach four
bottom screws. Connect door switch harness to
switch in new location. Install door assembly and
four front panel side screws loosely. Refer to
.
10. Check lint panel fit, adjusting front panel up or
down as required. Tighten four front panel side
screws to maintain position of front panel for
proper lint panel clearance.
11. Remove lint panel. Fully tighten bottom screws
on front panel.
12. Reinstall top screws and guide lugs.
13. Adjust door catch if necessary to allow
7 – 15 pounds pull (0.48 – 1.03 bar) at center of
handle.
14. Reinstall control assembly using mounting
screws.
15. Reinstall control panel and lint panel.
IMPORTANT: Restore power to tumbler and test
for proper operation of loading door switch.
Tumbler should not start with door open; an
operating tumbler should stop when door is
opened.
NOTE: If machine is converted back to right hand
hinge operation, the door switch harness must be
rerouted and rebundled with the lint panel switch
harness. Wire ties must be used to secure harnesses.
Wire ties (Part No. 55881) can be ordered from
RSPC.
Figure 9
TMB1997N
1
Switch (New location)
2
Plug (New location)
3
Door Assembly
4
Side Screw
TMB1997N
1
2
3
4
Summary of Contents for AT050E
Page 2: ......
