7. Ensure threads and gaskets are free of dirt anddebris.
8. Reinstall F1XX end cap by hand, tighten by turning clockwise until hand tight and the gasket is seated
Figure8.
9. Tighten both set screws on the end cap and the lens cap of the housing.
Figure 9.
Set Screw (same on lens cap)
INSTALLATION
10. Install the F1XX-WM wall mount.
11.Remove the protective film after installation. If the protective film is not removed in a timely manor
damage to lens is likely to occur with UV exposure
12.Apply power. For internal equipment startup procedures, setting changes, and troubleshooting
guides reference the camera manufacturer’s manual included with the “F1XX" Series Cameras. If the
included copy is lost, please contact
for a PDF copy.
Figure10.
F101-P137(5,7,8)-BD REV 2 114309212018 F1XX
SERIES INSTALLATION REV-2A
20