5
The standard model is designed to dial a pre-programmed number or
the last dialed number on the cell phone (not included). Please refer to
your phone manual to setup the number to be dialed.
Phone Setup —To view setup video, visit www.specmeters.com
Position mounting plate on phone to determine which slots on either
end should be used for weaving the tie strap. The rough side of the
mounting plate should be facing up.
See figure 1.
The smooth side (back) of the mounting
plate has an indentation, so when it is
sitting on top of the phone buttons it will
not touch them. To test if the mounting
plate is in the proper place, press on
the sides of the plate to ensure the
phone is not activated. If the phone
does light up, then reposition the
mounting plate over the phone buttons.
Weave tie strap through the mounting plate slots that are closest to the
phone and then through the hole in the strap itself. See figure 2.
Put extra piece of Velcro (fuzzy strip)
on back of phone so the tie strap can
adhere to it and secure mounting
plate in place.
If it is difficult to attach the mounting
plate without it contacting the buttons
then contact Spectrum Technical
Support for suggestions and solu-
tions.
Standard Model Setup
Figure 1
Figure 2
