14
Power Alert Installation
Feed the power cord through the gland.
Plug the sensor cord into the sensor
port. Adjust the relay/housing to fit in
the case. Tighten the gland nut.
Close the case.
Plug (P120) or wire (P24, P12) the
power cord into the circuit you want to
monitor. For setup limit, set the volt-
age limit to alert below 1 Volt.
Insert Relay/ Housing H
ere
Sensor Port
The P120 (120VAC) model includes a
protective housing for the sensor relay.
Once fed through the gland, the power
cord must be connected to the sensor
relay.
Open the protective housing (using a
Phillips screwdriver, not included).
Plug the two power wires onto the A and B
spades on the relay.
Place the relay into the
protective housing. Reas-
semble the protective
housing using the 4
screws.
