15
When power is attached, weather station or Retriever should
immediately power up as well.
-
The DataScout will flash green for approximately 30 sec-
onds. It will then briefly flash amber and shut off.
-
The Retriever will go into Setup mode, flash green for ap-
proximately 30 seconds, and then flash amber. See Retriever
& Pups Wireless Network product manual for further details.
-
The weather station will beep and the display will illuminate.
5.
Wait 1 minute after powering the DataScout modem to check
signal strength and confirm acceptable communication.
Press and hold the DataScout button until the light comes on
(approximately 2 seconds) to initiate the test. If, after several
attempts, communication is still unsuccessful (red LED), try
moving the DataScout to an area with better signal coverage.
Figure 3. WatchDog 2000 Series
Station and DataScout
Figure 4. Retriever and
DataScout
