0119327R1 Page 17 of 18
Honors Lectern Troubleshooting Guide
Symptom
Problem
Solution
Worksurface will
not operate
Loss of power
Be sure control box is plugged into a live circuit.
Loose electrical connections
Make sure all electrical connections are securely plugged into the control box.
See wiring diagram on p.11 for reference.
Object encountered under
the lectern worksurface
1. Raise the worksurface by pressing the “up” button.
2. Remove any items under the lectern worksurface.
3. Reset the lift mechanism (see below for procedure.)
Misaligned actuators due to
unbalanced loads
Reset Procedure
1. Unplug, then re-plug the power cord into a wall outlet.
2. Make sure all lift mechanism wire connections are in place and secure.
3. Remove anything located under the lectern worksurface.
4. Press and hold the “Down” button until the lectern stops moving. Release the
“Down” button.
5. Press and hold the “Down” button again and hold for 35-45 seconds. The
actuators have now been reset and the worksurface can be adjusted normally.
