0192095 Page 4 of 4
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2020 Spectrum Industries Inc., All rights reserved.
Figure 7
5. Attach support panel
5. Attach support panel
1. Align the support panel as shown.
Figure 5
.
2. Secure to the legs with (4) 8-32 x 1/2” PH thread-cutting screws.
3. Tighten ALL screws.
Figure 6
7. Attach headphone hanger
7. Attach headphone hanger
1. The headphone hanger can be attached to the left or right-side of the
desk using (3) #8 x 5/8” PHSM screws.
Figure 7
.
8-32 x 1/2” PH
thrd ctg
(2 per leg)
8. Flip desk upright
8. Flip desk upright
1.
Using two people, carefully flip the assembled desk upright.
Figure 8
.
(3) #8 X 5/8”
PHSM
Support panel
Headphone
hanger
Figure 8
Worksurface
CAUTION
Do not allow the desk legs to contact the floor until
the table is completely flipped over. Excessive
side-loading of the legs could cause damage.
6. Attach metal leg panels - optional
6. Attach metal leg panels - optional
Figure 5
Acrylic leg
panel assembly
8-32 x 1/2” PH
Thrd ctg
(4 per panel)
1. The upper rear screw is shared with the cord channel.
2. Attach the panel to the inside of each leg with (4) 8-32 x 1/2” PH
Thread cutting screws.
Figure 1
.
Leg
