Moving the lectern
0107155R1 Page 7 of 10
1. Before moving the unit, unplug all power cords and retract power cord into the reel (if equipped).
2. Be sure the casters are in the unlocked position and the doors closed.
3. Move the lectern slowly and carefully.
4. Lock the casters after moving.
brake lever
Caster operation
1. To lock the caster rotation, press the brake lever.
2. To resume rotation, lift up on the brake lever.
Floor anchoring (toe kick versions only)
1.
If your Doctorate Lectern is equipped with a toe kick, and you wish to attach it to the floor, the toe-
kick will need to be detached from the lectern. To detach, remove the (4) 1/4-20 x 35mm JC bolts
(one on each corner) from inside the lectern.
Figure 7
. (Save these fasteners).
2. Carefully lift the lectern off the toe kick and set aside. This will require several people.
3.
Determine and locate the toe kick into its final position on the floor and mark the (4) mounting hole
locations on the floor. (The toe kick mounting holes are 1/2” dia.)
4.
Drill suitable holes into the floor and anchor the toe kick with appropriate fasteners.
5. Carefully lift the lectern back onto the toe kick and align the (4) mounting holes.
6. Re-attach the lectern to the toe kick with the previously removed JC bolts.
7. The access panel can be removed to access wiring below lectern.
Figure 7
Note: (4) fasteners are req’d to anchor the
toe kick to the floor. Due to the wide variety
of flooring materials and conditions possible,
anchor fasteners are not provided.
(4) 1/2” mounting
holes for floor anchors
1/4-20 x 40mm JC bolt
(access from inside lectern)
4 req’d
access
panel
toe kick
Tools
Required
4mm hex
wrench
Drill
Figure 6
