0107155R1 Page 5 of 10
Overbridge insert panel (overbridge lecterns only)
1. To remove the insert panel, remove the (2) 1/4-20 x 35mm JC bolts with a 4mm hex
wrench and lift out the panel.
Figure 5A
.
2. To make cutouts in insert panel (optional):
3. Install controller(s) / electronics into panel.
4. Re-install the overbridge panel and secure with (2) 1/4-20 x 35mm JC bolts.
Note: The insert panel shown
(shaded)
is not included with the lectern or over-
bridge. This option needs to be ordered separately to complete the overbridge.
Figure 5A
1/4-20 x 35mm
JC bolt
overbridge
panel
Tools Required
1/4-20 x 35mm
JC bolt
A. Identify all location(s) and sizes for controller(s) or electronics while making sure
all devices fit within the maximum cutout space available in the overbridge panel.
See
Figure 5B-C
.
B. Locate and mark the exact cutout area(s) on the panel.
Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
C. Carefully make the cutout(s) in the overbridge panel using a jigsaw or router.
4mm hex
wrench
jigsaw or router
drill
pencil
masking
tape
drill bit
measuring
device
