0120148 Page 6 of 13
Figure 7A
Optional Flip-up Shelf
Shelf grommet
Operation
The shelf will automatically lock into place when lifted into the
horizontal position with the levers released. To lower or flip-up the
shelf, press and hold the levers under each folding shelf bracket at the
same time while slowly lowering or raising the shelf. Do not exceed a
maximum of 35 lb of weight on the shelf. Do not move the unit while
the shelf is in the horizontal position.
Note: Power and communication wiring for document cameras, laptop
computers, and / or projectors placed on the flip-up shelf should be routed
on top of the audience-side of the shelf. Use of the shelf grommet hole for
wiring will result in pinching of the cords when the shelf is lowered.
CAUTION
Keep clear of pinch points during shelf movement.
Do not exceed 35 lb [15.9 kg] of weight on shelf.
Release lever
(press here)
Upper mounting position
Lower mounting position
Figure 7B
Tools Required
4mm Hex
Wrench
(included)
Jigsaw or router
Drill
Pencil
Masking
tape
Drill bit
Measuring
Device
Optional Overbridge Insert Panel Cutouts
1. Before you begin, refer to the panel dimensions in
Figure 8B
for
maximum recommended cutout sizes.
2. Identify the size and position (left, centered, or right) of each cutout
needed.
3. Identify the depth of your device to verify it will not interfere with the
worksurface or any other objects under the overbridge when the
panel is attached.
Figure 8C
.
4. When the cutout location(s) have been determined, locate and mark the
exact cutout area(s) on the panel with a pencil.
Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
5. Carefully make the cutout(s) in the panel using a jigsaw or router.
6. Set the panel into the overbridge frame opening. Note: It may be
necessary in some cases to install the electronic device into the
panel before attaching the panel to the overbridge.
7. Secure with (2) 1/4-20 x 35mm JC bolts and tighten securely.
8. Install (2) 2” grommets.
1/4-20 x 35mm
JC bolt
(2 required)
Overbridge
panel
Overbridge frame
2” grommet
Note: The overbridge panel is symmetrical. Rotating or flipping the
panel 180° and re-attaching to the overbridge will allow you to place the
cutout on the opposite side of the overbridge if necessary.
Figure 8A
