Figure 1A
Tools Required
0120148 Page 3 of 13
Skirt Assembly
Figure 1B
Director Lectern
Instructor-side
Phillips
screwdriver
3. Hook the skirt keyhole slot at the end of each side skirt over the pre-
installed #14 x 7/8” PHSM screw.
Figure 1C.
4. From inside the lectern (on audience-side) , install (2) 1/4-20 x 40mm
JC bolts through the base panel to secure the assembled skirt, and
tighten securely.
Figure 1C
Assembled skirt
Keyhole
slot
#14 x 7/8” PHSM
(pre-installed)
1/4-20 x 40mm JC bolt
(install from inside lectern)
1. Install 3-piece skirt
1. Attach the two side skirts to the audience-side skirt with (4)
8-32 x 1/2” PH Thread-cutting screws.
Figure 1A
.
2. Move lectern into position over the assembled skirt as
shown.
Figure 1B.
Side skirt
Side skirt
8-32 x 1/2” PH
Thread-cutting screws
(4 required)
Audience-side skirt
1/4-20 x 40mm JC bolt
(install from inside lectern)
Assembly / Setup
4mm Hex
wrench
(included)
Note: The skirt is designed to be easily re-
movable. It should be removed if the lectern
will be moved over long distances or thresh-
olds to prevent damage to the skirt panels.
Do not tip lectern to remove or install!
