SpectraPure
SpectraPure®Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
®
11
Refer to Figure 7 and determine the location for the drain saddle assembly and drain hole. It must be located above
the “P” trap (“U” shaped bend in drain pipe) on the sink side of the drain pipe. Place the half of the drain saddle with
threaded nipple at a pre-determined location. Slide a pencil through the plastic nipple and make a mark on the drain
pipe. Use a small punch and indent a start position to prevent the drill bit from wandering. Drill a 3/8” hole in the
drain pipe through the mark
on one side only,
do not drill through both sides of the drain pipe. Clean any loose
shavings from around the hole.
Refer to Figure 8 showing the drain saddle assembly sequence. Press nuts in back half of drain saddle assembly. Align the
front half of the drain saddle by inserting a pencil through the plastic nipple and the newly drilled hole in the drain pipe.
Install the back half of the drain saddle and clamp assembly to drain pipe by screwing in the mounting bolts until snug.
Figure 7: Drain Saddle Mounting Locations
DRAIN SADDLE INSTALLATION
Figure 8: Drain Saddle Assembly Sequence
