When setting up the transmitter vertical,
PlaneLok can be used at the Z- or X-axis.
1. Press and release the button
and select >>PlaneLok<<.
2. Press and release button to open the PlaneLok submenu;
to select the Z-axis (only GL422N) for vertical slope alignment
or the X-axis for vertical direction alignment use the buttons;
then press button to start PlaneLok X.
Note: When used in vertical mode, the receiver has to be placed with the
Photocell on the bottom side. For getting the best performance and a longer
operating range set up the HL760 at least 0.5 m (2 ft) above the ground.
Any loss of signal over an extended period of time (1 minute) causes the laser
to go into the HI-alert condition (beam turns off, rotor stops and a warning
message occurs at the LCD along with an audio signal).
PlaneLok mode can be reactivated after the Error message
has been deleted with the button.
Automatic Vertical - PlaneLok