Q What if someone bumps a tripod
A The laser transmitters have a sensor to detect disruption
that will alert the operator to recheck alignment.
Additionally, there is a quick alignment check function
available which can be used at any time.
Q If there is a hole or bump in the floor, does it affect
accuracy?
A No, the intersection of the X is an accurate location. The
use of the Interceptor may help with rough floors.
Q Should I power down lasers and/or controller during
lunch
A It is not necessary, unless you are concerned about your
battery power level. Most crews leave lasers and controller
on during lunch.
Q What is the operating range?
A Depends upon lighting conditions and laser placement.
Red lasers generally cover an area of 100 x 100 ft (30x30m)
with single set up. Green lasers cover an area 130 x 130 ft
(40x40m).
Q What if accuracy is poor.
A Check set up. Check distance between benchmarks. Has
the system been "Leap Frogged?" Check axis alignment
Q Laser units do not charge
Should flash yellow (greenish looking) during charging.
Verify electric power. Trouble shoot if battery or charger is a
problem by using the other charger.
Q System failed “Check Alignment
A Try a second and third time. Restart axis alignment.
43
FAQ -
Operation
Q What if following set up, the calculated distances does
not match my measured distance? What difference is
acceptable?
A Generally, if measure distance is less than 10 ft (3m), seek
an accuracy within 1/16 inch (1.5mm). With longer verification
distance, you can expect large discrepancies.
Q What does it mean when both laser beacons are green.
A The system has lost communication between the controller
and lasers. Exit the application and power the lasers off and
try again. Note that the controller should indicate
communication break (X on laser).
Q What can be done if communication is lost several times?
A Exit the QML application and turn off both lasers. Power on
1 laser, wait 5 seconds and power on the second laser. If the
second laser unit dome light turns blue, launch the QML app.
If the second laser dome light turns green (both dome lights
are green) then there is too much Wi-Fi congestion. Try
moving lasers very close together while powering on.
Consider changing the channel.
Q Control points are not accessible.
A Are other control points accessible? You can create a new
control point offset from the original control point, be careful
to save the new point location correctly
Q Laser lines are not on
A Check if there is a message to check axis alignment. Check if
both domes are green. Stake a point.
Q Rotor Stalled
A Make sure the laser has a good charge. Try to gently
turn/wiggle the rotor. If this does not work, arrange service
Summary of Contents for QuickMark Layout QML800
