1. Press
once to play/pause in music mode
2. Volume control/previous & skip songs must be controlled directly on your audio device (no
built-in microphone for answering incoming calls)
To Charge the T252
1. Insert micro USB into the T252
& connect the USB output to a certified wall adapter (not
included)
2. Solid red LED indicates the T252 is charging (Red LED will automatically turn off once the
T252 is 100% fully charged)
To wirelessly charge an electronic device using the T252
** Make sure your device has integrated wireless charging capability or is equipped with wireless
charging adapter
(NOTE: some electronic devices with integrated wireless capability may
require users to manually enable wireless charging in the settings of their electronic devices)
1. Insert micro USB into the T252
& connect the USB output to a certified wall adapter (not
included)
2. Center your electronic device on top of wireless charging dock (see # 5 of Product Map
above) & power ON the T252. Flashing green LED indicates the T252 is wirelessly charging
your electronic device (NOTE: the flashing green LED lights will be lit while wirelessly
charging your device & will remain lit once your device is fully charged)
3. To stop charging, remove your electronic device from the charging dock
NOTE: to activate the wireless charging dock, the micro-USB/USB charging cable (included) must be
inserted to the T252 & connected to a certified wall adapter (not included)
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning
:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 18 of the FCC Rules
The interference potential of the device or system.
Maintenance of the system.
Simple measures that can be taken by the user to correct interference.
For RF lighting devices, provide an advisory statement, either on the product packaging or with
other user documentation, similar to the following:
This product may cause interference to radio equipment and should not be installed near maritime
safety communications equipment or other critical navigation or communication equipment
operating between 0.45-30 MHz.
