82
7-7-4. Device
Select
Device
to set Spot Out, Enable/Disable CVBS Out, motion zone.
ALARM OUT:
Set the sensor, motion, and video loss for triggering alarm relay.
HDD Error and Video Loss can be set for triggering a beeping sound
The following settings can be changed to trigger an alarm output.
o
ALARM DURATION
DIGITAL DETERRENT:
The schedule of digital deterrent can be set and a sound file can be
uploaded to the HS.
To set up schedule, select
CHANNEL >
select
SOUND TYPE >
select
Area.
CONTROLLER:
Set the controller baud rate and ID.
PTZ:
Set the PTZ baud rate, protocol, and ID.
SPOT OUT:
o
SPOT ON EVENT:
Enable/disable channel change if an event occurs on a channel
o
SEQUENCE:
Enable/disable sequential display of spot channel in full screen
o
SPOT CHANNEL:
Select a channel for spot monitoring using the mouse or the remote control
and press OK button
MOTION: Setup the motion detection area and the sensitivity.
o
SITE: Select the channel
o
MOTION ZONE:
FULL Zone or PARTIAL Zone
o
MOTION SENSITIVITY:
1~9 (High sensitivity level)
CHANNEL:
Select the Channel to configure audio input
o
AUDIO SOURCE:
Local Audio (RCA) or IP CAM Audio
KEYTONE
: Sets On or Off of Key Tone.
REMOTE CONTROLLER ID
: Sets an ID number of which remote control to receive commands.
SENSOR:
Select the type of sensor.
