5
ASSEMBLE THE HANDLEBAR
16.
Using the corresponding hex key, loosen (counter-
clockwise) and remove the four bolts on the stem
faceplate, then remove the stem faceplate from the
stem.
17.
Place the handlebar against the stem, then place
the stem faceplate over the handlebar with the stem
faceplate and stem holes aligned.
18.
Add a washer to each bolt and thread the bolts
through each of the stem faceplate holes into the
stem body making sure they are equally finger-
tightened.
19.
Adjust the handlebar to the desired position and
align it with the center of the bicycle.
20.
Adjust the handlebar to the desired position and
align it with the center of the bicycle.
21.
Using a torque wrench and corresponding hex bit,
torque each faceplate bolt approximately half a turn
at a time in an alternating (cross) pattern to the
specified torque setting found on the stem and/or in
the user manual.
22.
The gap between the stem and faceplate should be
even on the top and the bottom.
18
19
1
3
2
4
16
17
20
21
4
2
1
3
22
