Spearhead MULTICUT
820
11
Setting Up Your Machine
Height
To adjust the minimum cutting height, first raise the machine to take the weight off
the centre height bar, lengthen the bar by turning the barrel and raising the minimum
height stop. Lower the machine onto this stop to the new set cutting height. This
adjustable barrel only controls the minimum cutting height, however the operator may
raise and lower the machine via the hydraulic cylinder whilst the machine is in
operation.
Wings
Before attempting to raise (Fig. 5) or lower the wings always ensure the machine is
on level ground. To unfold the wings from transport position, first charge/pressurise
the rams with oil before releasing the locking strap. Then power the wings over
centre with the aid of the double acting rams. Lower both wings on the ground and
release the hydraulic pressure by placing the spool in float position.
Warning
Do not pressurise the wing rams out once the wing wheels have
contacted the ground. This will cause unnecessary strain on
the machine and may result in damage not covered under
warranty.
Fig.5 Wings
Warning
Do not attempt to raise or lower the wings until the machine is on level
Ground. Never travel before both wings are either fully down or fully
Up and the transport strap is correctly fitted.
