31
SpeakerCraft – 1-800-472-5555 – 1-707-778-5733
16 CHANNEL, FULLY CONFIGURABLE POWER AMPLIFIERS
INSTALLATION
BUS MATRIX™ LINE LEVEL AUDIO INPUTS
CAUTION! THE AMPLIFIER MUST BE OFF WHENEVER
YOU MAKE CHANGES TO THE INPUT CONNECTIONS.
STEP
DESCRIPTION
1. Label all of the interconnecting cables for the sources
they connect to.
Use audio patch cables with RCA phono plugs
attached to the ends.
2. Connect the sources by inserting the RCA
plug into the amplifier’s jacks.
Connect outputs from your sources to inputs on
the amplifier. Never connect a source or
preamplifier’s input (e.g., record inputs) to the
inputs of your SC16-50.
CASCADE AUDIO OUTPUTS
The Cascade Audio Outputs enable you to connect another amplifier to
your preamplifier output. The connectors are gold-plated RCA phono jacks.
Connect them to another amplifier’s inputs with a standard audio patch cable.
The outputs are not buffered.
AC POWER PLUG
STEP
DESCRIPTION
1. Plug the female IEC socket of the supplied AC power
cord (the supplied power cord is designed for 120V AC
wall outlets), or use an appropriate IEC AC power cord
to match the electrical wall outlet you are using (e.g.
240V AC), into the IEC receptacle on the rear of the
amplifier. Replace the fuse in the bay below the power
cord inlet with one of the 10A fuses provided if using a
220-240V outlet.
If you use a grounded power strip, surge
suppressor or extension cord, verify that proper
ground is maintained.
CAUTION!
Do not plug the amplifier’s cord into a
preamplifier’s convenience outlets.
The SC16-50 draws a maximum of approximately
1600 watts from an AC wall outlet. This is much
more than the typical accessory outlet on the back
of a component will provide. Use the SC16-50’s
auto turn on circuitry to turn on the SC16-50
whenever the preamp is on.
