background image

Nortek Security & Control LLC

3

Nortek Security & Control LLC

2

I

mportant

 S

afety

 I

nformatIon

1. 

Read these instructions. 

2. 

Keep these instructions. 

3. 

Heed all warnings. 

4. 

Follow all instructions. 

5. 

Do not use this apparatus near water. 

6. 

Clean only with dry cloth. 

7. 

Install in accordance with the manufacturer’s instructions. 

8. 

Do not install near any heat sources such as radiators, heat registers, stoves or other 
apparatus (including amplifiers) that produce heat. 

9. 

Only use attachments/accessories specified by the manufacturer. 

10.

Unplug this apparatus during lightning storms or when unused for long periods of time. 

11.

Refer all servicing to qualified service personnel. Servicing is required when the 
apparatus has been damaged in any way such as power-supply cord or plug is 
damaged, liquid has been spilled or objects have fallen into the apparatus, the 
apparatus has been exposed to rain or moisture, does not operate normally, or has 
been dropped.

FCC and IC Information

This device complies with Part 15 of the FCC Rules and contains license-exempt transmitter(s)/receiver(s) that 

comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

1. 

This device may not cause interference and

 

2.

 

This device must accept any interference,

 

including interference that may cause undesired operation of the device.

NOTE:

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Federal

 

Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause

 

harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio

 

or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference byone or more of the following measures:

 

 

Reorient or relocate the receiving antenna.

 

Increase the separation between the equipment and receiver

.

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 

Consult the dealer or an experienced radio/TV technician for help.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada 

applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d’en compromettre le fonctionnement. 

 

FCC AND IC Registrations

FCC ID: EF400212

IC:

 

1078A-00212

The digital apparatus complies with Canadian CAN ICES

3 (B)/NMB

3(B).

l'appareil numérique du ciem conforme canadien peut 

 3 (b) / nmb 

 3 (b).

WARNING:

 

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to

 

operate the equipment.

FCC and IC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the exemption from the routine

 

evaluation limits in section 2.5 of RSS 102.
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

FCC/IC RF Radiation Exposure Statement:

CAUTION:

 

This Transmitter must be installed to provide separation distance of at least 20cm from all persons.

FCC / IC RF Radiation Déclaration d’exposition

ATTENTION

: Cet émetteur doit être installé pour fournir une distance de séparation d’au moins 20 cm de toute personne.

WARNING:

 

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102, and users can obtain Canadian 

information on RF exposure and compliance from the Canadian Representative Product Solutions Group at Tel: (519) 763-4538.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 

DO NOT REMOVE COVER (OR BACK)  

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

The lightning flash with arrowhead symbol within an 

equilateral triangle is intended to alert the user to the 

presence of uninsulated “dangerous voltage” within the 

product’s enclosure, that may be insufficient magnitude 

to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is 

intended to alert the user of the presence of important 

operating and maintenance (servicing) instructions in 

the literature accompanying the appliance.

t

able

 

of

 C

ontentS

Important Safety Information   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .3

FCC and IC Information  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Unpacking   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .4

Care   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .4

Transmitter Connection .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .4

Receiver Connection .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .5

Adding Additional Receivers   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .6

Up to 4 Receivers can be paired to one transmitter . . . . . . . . . . . . . . . . . . . . . . . .6

Specifications   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .7

Attention: To Our Valued Customers   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .7

Limited 2-Year Warranty   .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .8

2-Year Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8

Summary of Contents for SC-WIR-TX






Reviews: