EAZYR PROGRAMMABLE REMOTE CONTROL
The EazyR comes pre-programmed with the IR commands for the
Eazy6
(See Diagram 11)
. To select an audio source, simply press the
relevant Source button, followed by the “Select” button. Selecting an
audio source will turn the relevant zone on. Volume up, Volume
down, Off and All Off will then function as described in the
“Operation” section below.
All other keys on the EazyR can be programmed with the IR
commands for the audio source components. For details, please refer
to the EazyR Owner’s Manual.
NOTE:
The Eazy6 features a non-volatile memory. This will prevent the
loss of learned codes should the remote control’s batteries run out.
Input Numbers
The following inputs on the Eazy6 relate to the following Source
buttons on the EazyR remote control:
Eazy6
EazyR
Input 1
Tuner
Input 2
CD
Input 3
Sat
Input 4
VCR
Input 5
DVD
Input 6
TV
OPERATION
Selecting any source input turns on the Eazy6, and will activate its “Status” output. Once the source has been selected, IR commands will only
be sent to that source. To turn any zone off, simply select the “Off” button on the EazyR. When the last zone has been turned off, the “Status”
output will be deactivated.
Volume commands will only operate when the zone is on. This will help prevent accidentally turning the volume fully up with no source playing.
The “All Off” button on the EazyR will turn every zone and the “Status”output off.
Eazy6 Owner’s Manual
Page 7
DIAGRAM 11:
EazyR Remote Control
Learn Button
Function Buttons
Reserved for Future
Eazy6 Functions
Source Buttons
Home Theater
The Expansion Outputs of the Eazy6 can also be used to share source components with a home theater amplifier. Simply connect the expansion
outputs of the last Eazy6 to the corresponding inputs of the home theater amplifier
(See Diagram 10)
. Video and Digital outputs of the source
components should be directly connected to the home theater amplifier, bypassing the Eazy6 altogether.
The SmartPath
™
IR connecting block CB6 has terminations for the IR receiver and a dedicated IR emitter for the home theater amplifier. Power
for the IR connecting block is provided by the 12-volt accessory output of the Eazy6. A Cat-5 patchcord is used to send IR data to the common
source components via either Data port of the Eazy6.
NOTE:
IR data from the SmartPath
™
IR connecting blocks will bypass the IR router in the Eazy6. To prevent operating two units simultaneously,
it is recommended that only one of any multiple sources be allocated for use in the home theater.
Page 6
Eazy6 Owner’s Manual
DIAGRAM 10:
Home Theater
