User manual
EXPERT 2K-FA
Pag. 52 of 52 Issue 2 – May 2011
Spurious emissions less than -60 dB ( 50 MHz –65 dB ).
3rd order distortion (two tone test) 36 dB typ.
- Input 50 ohm always perfectly matched
SWR less than 1.2:1.
- Fully protected
Temperature, Over-Voltage, Over-Current, SWR, Reflected Power, Max RF Tuner
Voltage, Over-Drive, Open/Short Output. The correct parameters are continuously
monitored.
The same protection is realized in two different ways:
·
Via hardware circuits (HW) to assure great speed.
·
Via the software (SW), to assure great accuracy.
Thanks to the SW, transmit relay changeover is carried out with zero current at
the contacts.
- Full break-in operation (QSK)
- Quiet operation.
Linear management of the speed of the cooling fans of the heatsink.
In the power supply, fans speed is reduced during the reception.
Since, considering the big power developed, a significant amount of heat
must be removed, every precaution is used to keep the lowest possible the
noise of the fans.
- Continuous use
“MAX” mode: SSB / CW unlimited.
Automatically switches to “MID” for a while if, in “MAX”, a continuous signal
(RTTY) is transmitted.
“MID” “LOW” modes, RTTY unlimited.
- Switching power supply.
Continuous input between 190 – 255 Vac. 47-63 Hz.
PFC (Power Factor Correction).
- The linear can be switched ON / OFF also switching the exciter ON / OFF
- Fully remotable.
- With a large LCD display is possible to have a great deal of information
W pep out, V pa, I pa, W, Power gain, Temperatures, SWR (after and before the
ATU), Input setting, CAT setting, Band and other indications including an alarms
log.
- Easy to operate
Powerful SW gives you a user-friendly unit.
- USB / RS232 ports .
For remote control..
For new SW releases download.
- Easy transportation
A sturdy carry-bag is supplied for “QSY, FIELD DAY, DX’ PEDITIONS etc.“.
- Certifications :
CE, FCC.
N.B. These specifications are subject to change without notice.