Spatz HDMI-GIGALAN-RX, User Manual

Page: 8 / 12

5
7. Operation Controls and Functions
7.1 Transmitter’s Front Panel
POWER
LINK PAIR SEL
LINK
HDMI/USB/IR/RS232 to CAT5e/6 Transmitter
① ② ③
① Power LED: The red LED will illuminate when the device is connected with
power.
② Link LED: The LED red will illuminate when the device has received input
source single and output display’s data.
③ LINK PAIR SELECT: This dip switch allows user with matrix setting for link up
to 16 pairs of the devices with single IP router. Each pair must have
the same dip switch setting in order to pair to the right device setting. The
factory default setting is at 0000.
7.2 Transmitter’s Rear Panel
HDMI IN
DC 5V
USB IN CAT5e/6 OUT RS 232 IN BLASTER
① ② ③ ④ ⑤ ⑥
①
DC 5V: Plug the 5V/2.6A DC power supply into the unit and connect the
adaptor to AC wall outlet. Power LED will illuminate when the power is on.
② USB IN: This slot is to connect with PC/Notebook for input source signal
with USB B type cable.
③ CAT5e/6 OUT: This slot is to connect with CAT5e/6 cable with receiver
side’s CAT5e/6 input.
④ HDMI IN: This slot is to connect with input source such as DVD or Blu-Ray
player with connection cable.
⑤ RS 232 IN: This slot is to connect with D-Sub 9pin female null moden
cable from PC’s system for controlling both the input source and output
display over RS-232.
⑥ IR BLASTER: This slot is to connect with IR blaster cable included in
the package for IR signal sending and controlling the HDMI input
source equipment.