Spatz HDMI-GIGALAN-RX, User Manual

Page: 9 / 12

6
7.3 Receiver’s Front Panel
POWER
LINK PAIR SEL
1 2
USB
3 4
LINK
IR CAT5e/6 to HDMI/USB/IR/RS232 Receiver
① ② ③ ④ ⑤ ⑥
① Power LED: The red LED will illuminate when the device is connected with
power.
②
Link LED: The LED red will illuminate when the device has received output
display’s single and input source’s data.
③ IR: receiver: This IR reciever can accept IR signal of the HDMI input source
device with frequency between 20~60Hz and can send the signal over
CAT5e/6 to transmitter side to control the input source equipment.
④ LINK PAIR SELECT: This dip switch allows user with matrix setting for link up
to 16 pairs of the devices with single IP router. Each pair must have
the same dip switch setting in order to pair to the right device setting.
The factory default setting is at 0000.
You can create mutliple groups (upt to 16) consisting of one TX and an
unlimited numbers of RX that are using the same LAN. So this is perfect for
fixed routed installs for unmanaged IP switches.
⑤ VIDEO MODE: Press this button to switch in between the video and
graphic mode. The OSD will display your selection every time when the
button is pressed.
⑥ LINK button: Press this button once or twice to allow the receiver to be link
up or unlink with the transmitter and the OSD will show "Starting USB" or
"Stopping USB" on the HDMI output display.
To connect a single transmitter to the desired RX, press the LINK button for
3sec to get the host control of USB on the HDMIGIGALAN-RX.
The HDMIGIGALAN con only link one USB connection at a time. Son only
one pair of TX and RX can communicate over USB. If there are more than
one receiver linked at one TX only the RX that has been linked will make
an USB connection.
⑦
USB 1~4: These slots are for users to connect with keyboard, mouse, HDD,
USB flash drive and…etc. for USB hub function and KVM usage.