6.
7.
LIMB
SAW
SET UP AND OPERATION
(cont.)
CHAIN TENSION:
Loosen 2 nuts holding chain guard cover.
See illustration below.
Loosen locking nut then adjust bolt. Screw bolt "out" to tighten chain, "in" to loosen.
Retighten locking nut after adjustment.
Chain tension should be the same as any hand held chainsaw. Do not over tighten.
Over tightening will
cause
chain to
stretch,
cause
additional wear and tear on the sprocket and additional strain on motor.
Re-tighten guard cover when adjustment is complete.
Never operate saw with chain guard loose or off.
Loosen bolts to adjust chain
Turn bolt to adjust chain. Keep chain at proper tension for optimum performance.
ADJUSTING CHAIN OILER FLOW:
1.
In the event your preset self oiler may need adjustment, remove outer motor cover to expose oiler.
2.
Loosen tiny allen set screw on oiler knob. To loosen and increase flow, turn knob counter clockwise. To tighten and
decrease flow, turn clockwise. Use extreme caution using no more than ½ turns to make adjustments.
3.
Position piece of paper or cardboard on ground and lower chainsaw blade over the paper.
4.
From the power unit seat, run your saw several seconds. Look to see if there is any oil splatter on the paper.
Adjust oil flow until you have a fine spray of oil on paper. When you have achieved the correct flow, reaffix outer
motor cover.
Loosen bottom set screw to free adjusting knob on chain oiler.
- 9 -
