Spartan Equipment
Technical Manual Skid-Pac
TM
1000, 1000B
22
IMPORTANT
Non-approved parts may cause loss of
performance or damage. Use only
genuine Spartan Equipment
replacement parts to protect total
warranty coverage.
11.8.2 Bearing Removal
CAUTION
Crush hazard. Be careful
that eccentric mass does
not fall and injure hands
or fingers.
1. Remove hydraulic hoses from motor.
Properly dispose of any spilled oil as
required by governing regulations.
2. Remove the hydraulic motor.
3. Remove the motor side bearing housing
from the eccentric housing.
4. Remove the eccentric mass.
5. Remove the other bearing housing.
6. With the bearing housing properly
supported, press out bearing. Press only
against the bearin
g’s inner race.
NOTE: Do not pry out the outer bearing race
if it remains in the housing. Place a small weld
bead, 1/8 inch (3 mm) along the inside
diameter. Allow it to cool, then remove the
outer race.
11.8.3 Bearing Installation
IMPORTANT
Handle new bearings with care to prevent
the grease seal from becoming dislodged.
(1000B model)
1. Clean the bearing housing.
2. Apply a light coating of oil to the bear
ing’s
outer race.
3. Slowly press bearing into housing.
NOTE:
Interference press fit. Press only against
the outer race
.
4.
Clean the eccentric shaft and apply a light
coating of oil. Slip bearing/housing onto
shaft.
NOTE: Close tolerance slip fit.
5. Repeat steps 1-4 with other bearing
/housing.
6. Install the bearings and eccentric in to the
eccentric housing. Tighten bolts to proper
torque.
Figure 11-4
Bearings & Eccentric - TD1615_5
7. Install hydraulic motor. Tighten bolts to
proper torque.
IMPORTANT
Torque bolts according to Table 11.1.
Follow special assembly instructions
noted in Section 11.12.
8. Install hydraulic hoses.
11.9 Spring Mounts - Replacement
The rubber spring mounts are subject to wear
and aging, thus requiring frequent inspections
and periodic replacement. Service life
depends primarily on use. Other factors,
including over-stretching and extreme
environmental conditions, can shorten mount
life.
CAUTION
Avoid injury. Some components of the
Skid-Pac are heavy. Use proper lifting and
support equipment.
Summary of Contents for SKID-PAC 1000
Page 2: ......
Page 46: ...Spartan Equipment Technical Manual Skid PacTM 1000 1000B 36 NOTES...
Page 47: ......
