Spartan Equipment COLD PLANER III Series, Operator'S Manual

Page: 37 / 41

MR25664 35
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
EXCESSIVE OIL
TEMPERATURE.
Hydraulic oil level too low. Refer to prime mover owners manual.
Obstruction in hydraulic lines. Remove obstruction and replace if
necessary.
A HYDRAULIC
CYLINDER NOT
OPERATING.
Hydraulic oil or oil filter in prime
mover is dirty.
Relief valve setting adjusted too
low.
Insufficient hydraulic flow from
the prime mover.
Refer to prime mover owners manual.
Refer to prime mover owners manual.
Refer to prime mover owners manual.
ALL HYDRAULIC
CYLINDERS NOT
FUNCTIONING.
HYDRAULIC
CYLINDERS ONLY
OPERATING IN ONE
DIRECTION.
Cylinder rod bent. Visually inspect the cylinder for
damage.
Cylinder seals damaged. Repair or replace cylinder seals if
necessary.
Obstruction in hydraulic lines. Remove obstruction and replace
hydraulic lines if necessary.
Blown fuse on prime mover. Refer to prime mover owners manual.
Damaged electrical wiring. Test and replace if necessary.
Damaged electrical wiring. Test and replace if necessary.
EXCESSIVE VIBRATION
DURING PLANING
OPERATION. Picks are worn or broken. Visually inspect the picks and
replace as necessary.
Picks contain flat spots or are not
rotating freely.
Insufficient down force due to
incorrect operating procedure.
Visually inspect the picks and
replace as necessary.
Refer to the Operating section of
this manual.