DRAFT
19
4.
When the camera shows that it is logged into the network,
perform the Hello test to confirm that the camera is
online.
a.
Press
Menu
.
b.
Scroll to the
Wireless
tab.
c.
Under
Diagnostics
, select
Hello test
then press the
OK
button. If your camera is connected to the network
properly, you will see the message
Success
.
5.
To test that the camera is taking and sending pictures
properly, in
Preview
mode, press
OK
to take a picture
then
OK
again to send it. If you are not setting up the
camera to send pictures, you may want to test your
camera using the instructions on page 28.
6.
After setting up and testing the camera, position it on the
target area and turn it on by sliding the power switch to
ON.
Please remember to switch from SETUP to ON after
the camera logs into the network.
The camera will take
pictures or videos as programmed. The height you mount
your camera depends on what your targets are, but 3-4
feet off the ground is generally best for wildlife.
7.
The green light on the front of the camera should flash
for a few seconds to give you time to move out of the
area. If it continues to flash for more than a few seconds,
you have left the camera in
SETUP
mode rather than
turning it
ON
.
Summary of Contents for GoCam
Page 7: ...DRAFT 2 ...
